The RTS trunking system consists of a RTS model TM-2000 and one or more RTS model ICP-2000 interconnection panels, depending on the number of intercom systems to be trunked. A backup TM-2000 may also be added to prevent downtime in the event of a failure of the main master control unit. The basic unit comes prepared to trunk eight matrices, and can scale up to 31 matrices.

The RTS trunking system consists of a RTS model MTM-2000 and one or more RTS model ICP-2000 interconnection panels, depending on the number of intercom systems to be trunked. A backup MTM-2000 may also be added to prevent downtime in the event of a failure of the main master control unit. The basic unit comes prepared to trunk eight matrices and can scale up to 16.

The ICP-2000 is a 1RU breakout panel that converts the SCSI type II connection provided from the TM-2000/MTM-2000 communication card(s) into 9-pin D-sub connections.

The RTS trunking system manages intercommunications between separate intercom systems using intercom ports that have been reserved and interconnected between the intercom systems. Keypanels or other data devices can then communicate with various destinations in other intercom systems via the reserved intercom ports. (This is different from bus expansion, in which the bus systems of two or more frames are interconnected to form one system with decentralized hardware.)
The RTS trunking system consists of an RTS model TM-2000/MTM-2000 and one or more RTS model ICP-2000 interconnection panels, depending on the number of intercom systems to be trunked. A backup TM-2000/MTM-2000 may also be added to prevent downtime in the event of a failure of the main master control unit. When both main and backup control units are used, an RTS model SWP-2000 switch over panel is required.

The SWP-2000 is a 1RU switch over panel that provides common connections for TrunkEdit and Trunk Supervisor Software packages, status monitoring of both TM-2000/MTM-2000 units and control of both units when used in a redundant configuration.

TrunkEdit is the GUI interface for programming the TM-2000 or MTM-2000 trunking devices. The TrunkEdit program allows the user to set up all the necessary parameters required for trunking multiple intercom systems. Each intercom system can be configured to work together as a virtual integrated single intercom system while still maintaining each individual system?s autonomy.

The Trunk Supervisor Software program is a trunking system management application. The program allows for real-time monitoring of trunk line status information. When used in combination with the Auto-TIMS III test set, it allows for fully automated testing of a trunked system. If a trunk line is found to be out of specification the trunk line can be pulled out of service until the issue is resolved. The program also has the capability of remote notification of user defined alarm events.

The RT-2M is a telephony industry audio test set. The unit can be used to verify that trunking audio path are working within user defined specifications.
The RT-2M contains both a signal generator and test measurement set internally and can be fully automated through the use of an RS-232 remote control port.